TCI drill bit IADC537 9 1/2″(241mm) for hard rock oilwell
Product Description
Tricone bits are available in new steel tooth and tungsten carbide insert, size from 3 3/8"(85.7mm)to 26"(660.4mm) for use in all formations, with any bearing/seal type, and a wide range of additional custom features.Tricone bit, are widely used in mining, oil well, water well, thermal drilling.
Tricone bit Included Steel Tooth (also referred to as milled tooth) bits and Tungsten Carbide Insert (TCI) bits,TCI bits are much more durable than Steel Tooth ones, but carry a higher cost to manufacture.
Both these two groups of Tricone Bits are available with
(1) Open Bearing or Sealed Bearing
(2) Roller Bearing or Friction Bearing (Journal Bearing)
(3) Gage Protected or Non-Gage Protected, etc
Product Specification
|
Basical Specification |
|
|
Size of Rock Bit |
9.5 inches |
|
241.3mm |
|
|
Bit Type |
TCI Tricone Bit |
|
Thread Connection |
6 5/8 API REG PIN |
|
IADC Code |
IADC 537G |
|
Bearing Type |
Journal Sealed Bearing with Gauge Protection |
|
Bearing Seal |
Elastomer or Rubber/ Metal |
|
Heel Protection |
Available |
|
Shirttail Protection |
Available |
|
Circulation Type |
Mud Circulation |
|
Drilling Condition |
Rotary drilling,high temp drilling,deep drilling,motor drilling |
|
Nozzles |
Three Nozzles |
|
Operating Parameters |
|
|
WOB (Weight On Bit) |
24,268-54,155 lbs |
|
108-241KN |
|
|
RPM(r/min) |
50~220 |
|
Formation |
Medium formation with low compressive strength,such as medium,soft shale,medium soft limestone,medium soft limestone,medium soft sandstone, medium formation with harder and abrasive interbeds,etc. |
9 5/8" TCI tricone bit is special size between 9 1/2"and 9 7/8",the special size is always working with 9 1/2" or 9 7/8" to slove shrinking problem in abrasive rock driiling.
